When the led linear lamp is used for interior decoration, the installation is very simple. Each of our wholesale led linear lights has a strong self-adhesive 3M double-sided tape on the back, and the sticker on the surface of the 3M double-sided tape can be directly removed during installation. Then fix the light bar to the place where it needs to be installed and press it flat with your hands. The led linear lamp is a circuit structure composed of 3 LED lamp beads in series and parallel mode. Each 3 LED lamp beads can be cut and used individually. You can cut it off as long as you need to use it, but you need to pay attention to the pad .
Outdoor installation of led line light manufacturers pay more attention to the waterproof and firm installation of the light bar. The reason why led linear lights are installed in this way is mainly because the led linear lights will withstand wind and rain. If 3M glue is used to fix it, the 3M glue will decrease over time and cause the led linear lights to fall off. Therefore, outdoor installations often use card slots. The way of fixing, the place that needs to be cut and connected, is the same as indoor installation, but it needs to be equipped with waterproof glue to consolidate the waterproof effect of the connection point. Then use a special fixing clip to fix it. You can use an electric hammer to drill the eye or use a plastic expansion tube and screw to fix the clip.
LED linear lights generally have three voltages: AC220V, DC12V, and DC24V, so you need to choose a suitable switching power supply. The size of the power supply is determined by the power and connection length of the LED strip. It should be noted that DC12V and DC24V must not be connected to AC220V, otherwise all the lamp beads will burn out. DC12V can't be connected to the DC24V control power supply; otherwise the power will be more than doubled and the lamp beads will be burnt out easily. The AC220V lamp belt can be directly connected to the mains. RGB colorful LED lights need to use a controller to realize the changeable effect. Generally, 4 wires are used to distinguish black, red, green, and blue. Colorful light bars generally have common anodes, that is, one on the light bar is +12V connected to the black wire, the others are negative, and RGB is connected to the corresponding red, green and blue ports or power cords.
