The manufacture of LED wall washer can follow the following steps
1. First apply a little thermal glue on the intact aluminum substrate, which can assist the wall washing radiator to dissipate heat, and then solder the lamp beads one by one;
2. Install the wall-washing shell on the welded lamp bead board, and seal the two slots next to it. It is convenient to not leak the glue when filling the glue;
3. What needs to be filled with glue is to carefully fill the slot of the wall washer with silicone (white glue or black glue) that is easier to dry. The glue can also achieve the function of waterproof and heat dissipation;
4. After the silica gel is dry, check carefully whether the lamp beads are covered by the glue, and clean it if there is any;
5. It is to cover the panel glass of the wall washer, and then install the assembly head. The wall washer is manufactured in this way; (These wires must be connected in the assembly head before the assembly head)
6. The last link is aging packaging
The installation process of Puxin LED wall washer
1. Do the pre-installation work according to the location of the power supply;
2. Fix the lamp firmly with screws;
3. Connect the lamp to the power cord firmly, and wrap the unused thread with waterproof tape;
4. When installing and wiring, one branch power supply can connect up to 8-10 wall washers in series; or connect another power cord after 50 meters;
5. After the installation is complete, please check the installation circuit first to confirm that the installation is correct and there is no electrical short circuit, then connect the corresponding control power supply.