1，The side outlet of the wiring method of the two ends of the led linear lamp:
From the side of the aluminum material at the two ends of the linear lamp, choose a surface to punch an outlet hole about the size of the wire diameter. The waterproof butt wire is connected to the circuit board from this hole and threaded out from the side of the aluminum material. The advantage of installing it is that it can be done. Seamless connection, brightening effect, no dark areas, and very convenient installation. However, this installation method is not very convenient for hiding power lines and signal lines. The lines can only be exposed outside. Small buildings will see lines at close range, which is for the whole building. Not so beautiful.
2，The plug outlet of the wiring method at both ends of the led line:
The plug outlet is to open an outlet hole from the middle of the plug pieces at both ends of the LED linear lamp. The LED outdoor waterproof linear lamp with a very plugged outlet is different from the bottom hidden line and the side outlet. There will be a gap between the lamp and the lamp during the docking installation. In the actual application of lighting engineering, the gap of about 1cm will not have much influence on the overall lighting effect, because the light beam is scattered and can fill the missing part of the light by itself. The plug outlet cannot be seamlessly connected, and the aesthetics is slightly inferior to the bottom outlet. It is applied to the concealed grooves in various buildings and glass curtain walls. The advantage is that it is easy to install.
3, the bottom of the aluminum wire for the wiring method of the LED linear lamp:
The bottom outlet is to wash a notch from both ends of the linear lamp aluminum profile. Use a thread with a tail clip to deflate the tail clip to the aluminum gap, and put a screw on the plug. In addition to seamless connection of the bottom-outlet LED linear lights, the butt wire and power cord can be hidden at the bottom of the lamp, because the bottom-outlet linear lights are all H-shaped. The following is more convenient to hide the wire, and the installation of the bottom outlet is more beautiful for the building. Now customers choose this one more!