1. Paving fine sand: Spread 3cm thick sand in the position of the floor tile lamp and level it.
2, fill the gap: fill the gap of the floor tile lamp with fine sand 80%, do not fill up, put glass glue on the gap of the surface edge of the floor tile lamp to fix the brick light to prevent rainwater from infiltrating. After the glue is dry, touch it. The surface of the floor lamp should be level with the ground to avoid pedestrians being overwhelmed. Other methods such as lime slurry can also be used to fill the gap to prevent rainwater from seeping into the inverted water.
3. Light up: After installation, carefully check whether the line is correct, and then turn on the light after confirming that it is correct.
4, pre-embedded power cord: the power cord is pre-lead to the position of the floor tile lamp, leaving about 30CM length, with soft wires, color is better.
5. Wiring: Connect the wires of the brick light to the incoming power cable according to the wiring diagram, remove the wire and secure it, and avoid the damage caused by the fault of the joint contact, and wrap it with insulating tape.
6, installation: power supply, controller, guillotine leakage switch, installed with the distribution box, placed not into the water, no one touched the place (put indoor is better). Please refer to the installation wiring diagram when wiring.
7. Precautions: Please be careful when installing and installing. Do not hit the brick light with heavy or hard objects, play, etc., to avoid damage to the brick light. Non-installation construction personnel should not install it at will to avoid unnecessary accidents. Special circumstances should be consulted by the supplier.