1. Prepare
(1) Before installing the LED wall washer, first put the tin bar and soldering iron needed for the LED lamp bead,
Welded on the aluminum substrate, ready to use when installation.
(2) Check the installation materials first, if there is any problem, you can negotiate a refund or exchange,
Finally ready to install the toolkit.
2. Check
In order to ensure the quality of the installation, check the soldered board again, whether the power-on test can be
It is normally bright, to avoid the situation that it does not light up after the soldering is completed, and it needs to be removed and connected again.
3. If the lamps can be lit normally, first coat the heat-dissipating silica gel on the back of the aluminum substrate.
Then put the board inside the case.
4. Welding
(1) Weld the power cord on the positive and negative poles of the aluminum substrate, tie the two ends with tape, and
The glue must be fixed firmly.
(2) During the glue filling process, the overall level should be even and flat, do not slant or slant, which will affect the
installation effect.
5. If you use glue, in the afternoon of the same day, remove the remaining account, and then put the glass
Glass, and then plug the two ends of the wall washer installed.
6. Wire the installed wall washer light, pay attention to the interface of the outlet, do not connect wrongly, it is best to connect them one by one, after inserting the male and female, install according to the parameter control manual.
7. When making the finished product, power on first, then turn on the switch test to check whether it is normally bright, If abnormal, re-test the adjustment.