Many customers don’t know how to wire during use
1. First, strip the wires and wire the ends of the wires. The wire end of the two-pin plug is connected to the 220V power connector of the 12V power supply. When the power is plugged in, a green indicator light will always be on.
2. According to the one-way lighting principle of LED, the planner changed the structure of the luminaire so that the light distribution curve of the LED high bay lamp is basically the same as the point light source of the incandescent lamp. According to the lighting characteristics of LEDs, the structure of LED high bay lamps should be confused with incandescent lamps. It is divided into light source, drive circuit and heat sink. These cooperations can create low energy consumption, long life, high luminous efficiency, and environmental protection.
3. According to the survey, the price difference between LED lamps and energy-saving lamps is rapidly shrinking. Although LED lamps have the advantages of low energy consumption and long life compared with traditional light sources, their high-quality quotations have become an important reason to prevent LED lamps from bursting.
4. Connect the point light source to the controller and the 12V power supply. There is a current direction behind the point light source board (the power supply must follow the direction of the arrow, otherwise it will not be able to control or light up, or even burn out the point light source), and the pins are marked, It is OK to connect one by one according to the electric board wire of the lamp.
5. After wiring check, plug the 12V power plug and the controller plug into the AC 220V plug-in board and power on, and then you can display the light you want through the program.
The led point light source is one of the latest decorative lights. As a supplementary light source for linear light sources and floodlights, the design of LED point light sources is more convenient than other lamps.