How can we do a good job of waterproofing? Only when the waterproofing of the lamps is done, the outdoor lighting project led wall washer light can play its good effect and service life.
1. First, solder the lamp beads to the aluminum substrate with a soldering iron and a tin bar for use.
2. Then test the welded board to see if there is any virtual welding or no light, so that through preliminary aging, it can be ensured that the drive and lamp beads of the outdoor lighting project wall washer lights are in good condition.
3. After the test lighting is completed, put heat-dissipating silica gel on the back of the aluminum substrate, and put the board into the shell. The heat-conducting silica gel is to dissipate the heat of the lamp beads to the lamp body, so as to avoid the light decay of the lamp beads, and proceed to the next step.
4. The preparation process is done. Weld the power supply to the positive and negative poles of the aluminum substrate, and then bind the two ends with tape for glue filling.
5. The above steps have been completed, and the aging test is to be carried out, and the packaging is to be carried out.
When using such a lighting lamp, whether there is a scale plate next to the lamp, because such a plate is easy to adjust the angle of the irradiated light, so this plate must be provided. When choosing, you should choose the mode of the back switch that is suitable for you according to your own needs, which is mainly for the convenience of replacement and maintenance.