When LED linear lights are used for indoor decoration, the installation is very simple. The back of each type of LED linear lights we wholesale is pasted with 3M double-sided adhesive tape with strong self-adhesive. When installing, you can directly remove the sticker on the surface of 3M double-sided adhesive tape, and then fix the lamp strip at the place where it needs to be installed, and press it flat with your hand. The LED linear lights are a circuit structure composed of three LED lamp beads in series and parallel. Every three LED lamp beads can be cut off for separate use. You can cut off as long as you need, but you need to pay attention to the bonding pad.

LED linear lights manufacturers pay more attention to the waterproof and firm installation of the light strip when installing outdoor. The reason for installing the led line lamp in this way is that the led line lamp will be exposed to the wind and rain. If the 3M glue is used for fixing, the 3M adhesive will be reduced for a long time, which will cause the led line lamp to fall off. Therefore, the card slot fixing method is often used for outdoor installation. Where the cutting and connection are required, the method is the same as that for indoor installation, except that additional waterproof glue is required to consolidate the waterproof effect of the connection point. Then fix it with a special fixing clip, which can be drilled with an electric hammer or fixed with a plastic expansion pipe and screws.

The general voltages of LED linear lights are AC220V, DC12V and DC24V. Therefore, it is necessary to select an appropriate switching power supply. The power supply size depends on the power and connection length of the LED light strip. It should be noted that DC12V and DC24V must not be connected to AC220V, otherwise all lamp beads will be burnt out. DC12V cannot be connected to DC24V control power supply; Otherwise, the power will be more than doubled, and it is easy to burn out the lamp beads. The AC220V lamp belt can be directly connected to the mains. RGB colorful LED light band requires a controller to achieve the changing effect. Generally, 4 lines are used to distinguish black, red, green and blue. Colorful light bars are generally common anode, that is, one of the light bars is+12V black wire, and the other is negative. RGB is connected to the corresponding red, green and blue interfaces or power lines.
